Roland Metaza MPX-80 Uživatelský manuál stáhnout pdf (Strana 78)

Chapter 5 Maintenance and Adjustment

5-4 Adjustment of the Origin-point Location

Adjusting the Location of the Machine's Origin Point

The machine's printing origin point is at the center of the table's scale. When you want to adjust the origin-point

location, output calibration data to verify the location of the origin point.

Print calibration data.

➊

Mount material on the center of the table.

Prepare material measuring at least 20 mm (0.8 in.) square.

☞ P. 31, "Loading Material (Using the Adhesive Sheet)," p. 33, "Loading Material (Using the Center Vise)"

➋

Start METAZAStudio.

➌

Go to the [File] menu and click

[Open].

For [Look in], select the [Samples]

folder in the [METAZAStudio]

folder*.

* The folder where METAZAStudio is in-

stalled

Select [Axis.dmz].

Click [Open].

➍

Start printing.

Measure and type in the correction values.

➊

Measure and note down the offset between the centerline

on the table scale and the crossed lines on the material.

In the example shown in the figure, the [Width] value is displaced

by 0.5 mm in the positive direction and the [Length] value is offset

by 0.5 mm in the negative direction.

-0.5 mm

0.5 mm

Center line

Positive direction

for [Length]

Positive direction

for [Width]

Material

Center line

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 95 96

Žádné komentáře

Roland Metaza MPX-80 Uživatelský manuál Strana 78